I have an MGB Tonneau Bar that I am converting to use with my 1960 BT7
Healey. It fits in the bar holes perfectly after cutting off the tabs, but
sits much too high. Could some one give me a measurement from the floor up to
the bar when it is installed. I need to cut the legs of the bar so it sits at
the right height and since I have never used a Healey tonneau cover or seen
one installed at face value, I am clueless as to how high the bar should sit
in the holes. If there is another measurement that would work better send it
along.
Also, this bar has a slight bow to it. If the Healey had a bow did it face
forward or rearward or was it perfectly straight in all directions?
Thanks, Mark
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|