When the car is painted only little primer/paint will end up in (these
lower) seams. Using the correct type of Waxoil, Tectyl or similar in the
cavities will also protect most seams and if you apply some externaly on
the seams you have 100% coverage. It has a high penetration in the seams
and if applied properly (just a mist will do) will not crack. Make sure
no water can be trapped in cavities by drilling 1/2" holes in the lowest
points (front and rear) and remove the ex- and internal burs. In most
cars these holes are already present or there are raised parts in the
welding flanges of the seam to create a channel. Insert a suitable bar
in the hole and move the bar backwards to lower the front of the hole
and raise the rear. This creates a slight vacuum on the move and will be
the cause of some air circulation in the cavity.
Clear these holes or channels regularly to keap them open. Repeat the
Waxoil treatment every 2 years or so.
Kees Oudesluijs
Bob Spidell schreef:
> You mean fill all the seams and cracks under the car? I'll take your word for
>it Rich, but I'm not comfortable with the idea. I think any compound--paint,
>sealer or otherwise--will be compromised eventually and trap water. But, I'll
>certainly defer to your experience.
>
>
> bs
>
> --------------------------------
> Bob Spidell - San Jose, CA
>
> ----- Original Message -----
> From: "Rich C" <richchrysler@quickclic.net>
> To: "Bob Spidell" <bspidell@comcast.net>, "john spaur"
><jmsdarch@sbcglobal.net>
> Cc: healeys@autox.team.net
> Sent: Thursday, February 18, 2010 2:33:51 PM GMT -08:00 US/Canada Pacific
> Subject: Re: [Healeys] Seam sealing extent
>
> I respectfully disagree with this thought Bob. The seam sealers we have
> available today aren't the same ones that cracked and fell out of our cars
> the first time around, some 45 years ago. A good smooth fillet of sealer
> between under floor and chassis that takes paint is going to keep that
> moisture out.
>
> Rich Chrysler
>
>
> --------------------------------------------------
> From: "Bob Spidell" <bspidell@comcast.net>
> Sent: Thursday, February 18, 2010 2:43 PM
> To: "john spaur" <jmsdarch@sbcglobal.net>
> Cc: <healeys@autox.team.net>
> Subject: Re: [Healeys] Seam sealing extent
>
>
>> Just did this on our BN2. I sealed seams on the top side--cockpit, boot,
>> etc.--and left them open underneath. The idea is to keep water from
>> seeping in, going with gravity, on the top and to let it flow out, again,
>> going with gravity on the bottom. IMO, seam sealer on the underside is
>> like undercoating; since no sealant is perfect forever the sealer just
>> becomes a means to trap water.
>>
>> Bob
>>
>> --------------------------------
>> Bob Spidell - San Jose, CA
>>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as coudesluijs@chello.nl
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|