Howdy List,
I have a BJ8 engine/trans/OD that I hope to rebuild some day and put in
my BN4, which is showing a lot of fine brass bits brass bits in the oil pan
during the oil change. I also have 2 HD8 carbs, but I need a new float
chamber for the front carb, as the one I have is the same as is on the rear
carb.
I also need the carb linkage parts to complete the "kit". I know this has
been done many times out there, so I'm looking for the tech info and the
parts to accomplish this project. Looking through the Moss and VB catalogs,
many of the parts are not available, and the drawings are difficult for me
to visualize the actual arrangement on the engine, so if someone has a
picture or two of the carbs that would be very helpful also. The pics in
the Anderson & Clausinger books don't show the linkage.
Thanks in advance, and think spring!
Gordy
BN4 Fenton, MI
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|