Sounds about normal for Burlen.
Cheers.......Bob
Check out our web site www.autofarm.net
----- Original Message -----
From: "Quentin Schweninger" <quenty@ntelos.net>
To: "Healey List" <healeys@autox.team.net>
Sent: Tuesday, February 09, 2010 4:42 PM
Subject: [Healeys] Burlen-Su Pump kit Problem.
>I purchased a Burlen Electronic Conversion Fuel pump kit from Burlen
> in the UK. This was to convert the original BN7 fuel pump.
> However the bushing they furnished for the Diaphragm shaft was too
> large for the hole in the core.
> I decided to install the kit on my spare AZX 1300 Series pump.
> After installation the pump refused to to cycle. As I pushed the
> "hall Shield" in , per their instructions the pump would
> buzz but not cycle.
>
> On Jan 10 I sent them an Email explaining the problem. No response.
> On Jan 24 I sent another, "any body home?" No response.
> On Feb 1 I sent another," IS IT YOUR INTENT TO IGNORE ME?" No response.
>
> Great Customer Relations.
>
>
> Any one else had this problem?
>
> Dave & Daisy BN7 II
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as autofarm@cyg.net
>
> http://www.team.net/archive
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.435 / Virus Database: 271.1.1/2677 - Release Date: 02/09/10
07:35:00
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|