Re: [Healeys] 100 BN2 Emergency 4 way flasher

[Alan Seigrist <healey.nut@gmail.com>]

Thomas -

If you've purchased the Lucas 4 way flasher kit, it is actally fairly
easily installed.

Take the power lead off a brown wire (unswitched fused power) (off the
fuse box) and then run 4 seperate wires to each of the outward bound
light leads from the flasher relay.

Finally the power cutout circuit in the Lucas switch should have the
brake switch circuit routed through the cutout (rather than the
flasher in the Lucas instructions in the box), this keeps the brake
switch from overiding the whole thing if you are rolling to a stop.

I can give more specifics in a couple days...

Alan

On 1/17/10, T+ B Willig <willig@wtnet.de> wrote:
> Hi,
>
>
>
> I need some advice how to install a emergency 4 way flasher on my BN2. I am
> a bit scared to burn the expensive  flasher relay.
>
>
>
> Thanks
>
>
>
>
>
> Thomas Willig
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as healey.nut@gmail.com
>
> http://www.team.net/archive
>

-- 
Sent from my mobile device

Alan

'52 A90
'53 BN1
'59 Jag Mk IX
'64 BJ8
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive