healeys
[Top] [All Lists]

Re: [Healeys] Grille surround and top cowl MkII BT7

To: "Rich C" <richchrysler@quickclic.net>, "Simon Lachlan"
Subject: Re: [Healeys] Grille surround and top cowl MkII BT7
From: "Bob Yule" <autofarm@cyg.net>
Date: Sat, 16 Jan 2010 10:19:01 -0500
    Like he said!!
Cheers.......Bob
Check out our web site www.autofarm.net
----- Original Message ----- 
From: "Rich C" <richchrysler@quickclic.net>
To: "Simon Lachlan" <simon.lachlan@homecall.co.uk>; <healeys@autox.team.net>
Sent: Saturday, January 16, 2010 10:03 AM
Subject: Re: [Healeys] Grille surround and top cowl MkII BT7


> Simon,
>
> On the later grille assembly, the upper brow is preassembled into the 
> upper
> portion of the oval surround, so that the oval lip is exposed all the way
> around and the 3 upper tabs are lined up with and immediately behind the 3
> captive nuts of the brow. This assembly is carefully inserted into the
> shroud aperture, and then working from behind the grille opening, 4 
> special
> 1/4" NF studs with a hex surface half way along the stud are run forward
> into the two outer upper captive nuts in the brow, and into the two 
> captive
> nuts in the lower left and right brackets riveted to the shroud. There is 
> an
> additional small lag bolt in the top and bottom middle mounting flange 
> that
> runs through a fender mounting style captive clip.
> At this point you should have the surround and brow assembly nicely set 
> into
> the aperture and the back ends of the four special studs facing toward the
> rear of the car. The vertical teeth assembly is brought in carefully 
> behind
> the aperture from the side. The outer upper tabs fit onto the studs, as 
> well
> as the lower outer tabs to the lower studs. The upper ones can now have 
> flat
> washers, lock washers and nuts installed and run up, securing the upper
> portion of the teeth assembly. The lower studs now must also have the 
> lower
> brackets of the radiator air deflector panels installed onto the lower
> studs, along with the left and right steady straps for the inner wheel 
> arch
> splash plates. With all this lot run onto the lower studs, flat washers,
> lock washers and nuts can be installed and run home. Last, there is a 
> middle
> lag screw on the top and bottom of the teeth assembly that installs into 
> the
> bracket on the oval surround.
>
> Rich Chrysler
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as autofarm@cyg.net
>
> http://www.team.net/archive


--------------------------------------------------------------------------------



No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.432 / Virus Database: 270.14.145/2626 - Release Date: 01/16/10 
07:35:00
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>