I tried that but the trunnion doesnbt have enough shoulder for the gear
puller to grab onto. It kept slipping off.
From: Bob Spidell [mailto:bspidell@comcast.net]
Sent: Wednesday, January 13, 2010 2:36 PM
To: Drew Philippo
Cc: Healeys@autox.team.net
Subject: Re: [Healeys] King Pin with needle bearings
I think a small gear puller would work:
http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=8832
bs
--------------------------------
Bob Spidell - San Jose, CA
----- Original Message -----
From: "Drew Philippo" <dphilippo@gtp-eng.com>
To: Healeys@autox.team.net
Sent: Wednesday, January 13, 2010 11:26:55 AM GMT -08:00 US/Canada Pacific
Subject: [Healeys] King Pin with needle bearings
I tried this one last winter and I was unable to get the trunnion off of the
kingpin. I didn't have a lot of time to fool with it so after a weekend of
messing with it I put the whole thing back to the way it was and let it
wait. Does anyone have any suggestions for separating the two parts while on
the car?
Thanks,
Drew
65 BJ8
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|