Neil,
Take a used Hardi Spicer joint and dicover the groves.
Another smart a**.
Kees Oudesluijs
NL
Neil Anderson schreef:
> Bob,
>
> Not to be a smart a**, but you have heard of u-joints, haven't you?
>
> Neil Anderson
>
> -----Original Message-----
> From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
> On Behalf Of Bob Spidell
> Sent: Monday, January 11, 2010 8:07 PM
> To: sales@justbrits.com
> Cc: 4 - Healeys
> Subject: Re: [Healeys] King Pin with needle bearings
>
> What's the advantage to these?
>
> I know, it should be obvious, but I've heard it's not a particularly
> good idea to use roller bearings where the parts don't rotate
> completely; i.e. the parts rock back and forth on the same limited
> surface, possibly wearing grooves (if the parts/bearings don't rotate
> completely, it subjects one part of the bearing to the most wear).
> Specifically, I heard this about using needle roller bearings on cam
> rockers.
>
>
> bs
>
>
>
> Sales at " Just Brits " wrote:
>
>> << Sometime in the past someone on the list had mentioned
>> that there is a king pin setup for the big Healeys that uses
>> needle bearings instead of bronze bushings.
>> What I need is the supplier name and URL. >>
>>
>> I am in same 'boat' as Bob is Steve, don't have
>> in stock and I also expect in around 2 weeks
>> <sigh>.
>>
>> Ed
>> Please visit MY site at:
>> www.justbrits.com
>> _______________________________________________
>>
>
>
>
> ------------------------------------------------------------------------
>
>
> Geen virus gevonden in het binnenkomende-bericht.
> Gecontroleerd door AVG - www.avg.com
> Versie: 9.0.725 / Virusdatabase: 270.14.134/2613 - datum van uitgifte:
>01/11/10 08:35:00
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|