healeys
[Top] [All Lists]

Re: [Healeys] Clutch Alignment Tools - AH100

To: Bob Haskell <rchaskell@earthlink.net>
Subject: Re: [Healeys] Clutch Alignment Tools - AH100
From: John Harper <ah@jharper.demon.co.uk>
Date: Fri, 8 Jan 2010 16:21:28 +0000
Bob

You are correct in what you say. 'Clutchtools' do not advertise the 
correct tool for a BN1.

As a matter of interest I looked up the official BMC Service Tool 
Catalogue and I believe that there are errors in this.

Service Tool 18G79; that I believe is correct for a BN2 does not list 
the 100 at all. The only Healey listed is 100 six

Service Tool 18G80 lists A70, A90 Healey 100 and Healey 100 Six.

I maintain that 18G79 should include the 100 BN2 and 18G80 should not 
include Healey 100 Six but only list the Healey 100 suitable for a BN1.

Anyway the dimensions of my tools that are based on the above BMC tools 
have a pilot length of 2.00" and further length for the plate of 2.00". 
Mine are turned down from 8" lengths  of 1" diameter steel.

Regards
>
>If I was going to make a set, I'd make them like yours.  The only other 
>dimension I'd need would be the length of the pilot.
>
>There's a firm (http://www.clutchtools.com) that sells them for $10 and 
>their catalog incorrectly lists the same tool for all big Healeys.  I 
>thought it might be helpful to see if they have the tools with the 
>correct dimensions for the BN1 and BN2. Their tools are splined, so 
>that's the reason for my questions.
>
>Cheers,
>
>Bob
-- 
John Harper
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>