Yea, you didn't mention it was frozen. Is it threaded on or a taper fit? If
it is threaded on, you can chuck up a large allen wrench at the short end ("L"
shaped) by hand and strike the long end of the allen wrench with a hammer in
the loosening direction to hopefully unscrew it. Hope that helps.
Larry Wendland
'67 BJ8 (original owner)
-----Original Message-----
From: awgertoo@aol.com
To: bighealey3k@aim.com
Cc: healeys@autox.team.net
Sent: Sun, Jan 3, 2010 3:22 pm
Subject: Re: [Healeys] Chuck Key--No Healey content
In a message dated 1/3/2010 3:19:13 P.M. Eastern Standard Time,
bighealey3k@aim.com writes:
Take the chuck off of the drill press
Did I forget to say that the chuck is frozen and cannot be removed?
Best--Michael
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|