In a message dated 12/27/2009 10:19:06 A.M. Eastern Standard Time,
eschulz@frontiernet.net writes:
"the outer face of the bearing spacer should protrude from .001" to .004"
beyond the outer face of the hub AND THE PAPER WASHER when the bearing is
pressed into position."
---------------------------------------------------------------------
Elton--
The flange on the half-shaft is "dished" in the middle and the outer flat
portion will come in contact with the flat face of the hub and the paper
gasket which will compress and provide a seal.
Best--Michael Oritt
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|