Hi Peter,
Sort of. I have two drives (thanks hmj), each with some parts missing
or broken. I'm hoping to make one good one out of them.
I've heard of people lubricating these, but I can't for the life of me
figure out how to do it (unless you just drop oil in from either end).
bs
Peter Caldwell wrote:
> Bob, I used to rebuild these. Find a small socket that fits over the
> cable and is the diameter of the steel slug that holds the cable bit.
> Tap it with a hammer and the gear, shims and core plug will all drop
> out. When you reassemble, you'll dimple the housing to hold the core
> plug in.
>
> Are you going to repair a broken cable?
>
> Peter C
> ==
> At 03:32 PM 11/21/2009, Bob Spidell wrote:
>> Anybody taken these apart and reassembled? Any tech articles and/or
>> websites on how to accomplish this? It's not obvious or even
>> apparent how this can be done, or if it's even possible.
>>
>> TIA,
>> Bob
>
>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell@comcast.net
*******************************************************************
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|