I have need of the bearing shims and "plates" which are located at either
end of the gearbox main and input shafts. I'll probably have to make my own
from shim stock but could use some measurements as a starting point. The
parts book does not give gauge. Anyone have a set laying about they could
mic? It's a side shift BN4.
Thanks guys,
dave
frogeye@porterscustom.com
Porter Customs 2909 Arno NE
Albuquerque, NM USA 87107
505-352-1378
1954 BN2 1959 AN5
Porter Custom Bicycles
cars:
www.britishcarforum.com/portercustoms.html
gallery:
http://picasaweb.google.com/porterscustombicycles/PorterCustomBicyclesStuff
blog: http://porterbikes.com/
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|