Thanks to all who responded to my question about exhaust hanger replacements.
Guy,
I like these ideas. Think I'll use 1/2" countersunk flathead sheet metal
screws, staggered one from each side. Will take your advice about super glue in
the holes. Think I'll get some new ones and do it to those rather than fixing
the broken ones.
The ones you've superglued - have they lasted that way for years for you?
My engineer buddy recommended Gorilla Glue.
--
Steve Gerow
BN6
> Guy R. Day wrote,
>
> Use 'Superglue' to bond the two surfaces together but wipe them with a damp
> cloth to clean them first. Clamp them together for at least 30secs before
> testing and they should last as long as you do!!!!
> A slight amount of moisture assists in setting the glue so don't fully dry
> things off (but you don't want drops of water).
>
> If you are going to drill and screw into the rubber only go half way in from
> each side and put a squirt of superglue into the drilled rubber to stop the
> screw from vibrating and wearing the rubber into fine crumbs round the
> thread.
>
> If one side has gone on each one check the other sides. There must be a
> reason for them going in the first place. If you really want them to last
> paint the rubber / metal joint with a waterproof coating (varnish?) both
> before and after refitting.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|