Thomas,
The connectors are the same style as those used inside the license plate
lamp. They look like an elongated bell. Strip the insulation off the
wire, feed the wire up through the bottom of the bell until the bare
wire sticks through the top. Fold the bare wire over, spreading it out
around the bell and insert the connector into the socket.
Bob
Thomas Willig wrote:
> Hello,
>
>
>
> I need advise on the following questions about Lucas Altette Horns:
>
>
>
> 1. How are the wires from the wiring loom attached to the horns? Bullet
> connectors maybe? Who sells these connectors?
>
> 2. Does someone sell the rubbers, isolating plate and steep plate which
> hold the electrical connectors in place?
>
>
>
> Thanks
>
>
>
>
>
> Thomas Willig
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as rchaskell@earthlink.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|