healeys
[Top] [All Lists]

Re: [Healeys] rebuilding my BN4

To: Vern <vern@srvinet.com>
Subject: Re: [Healeys] rebuilding my BN4
From: Bob Spidell <bspidell@comcast.net>
Date: Thu, 8 Oct 2009 16:49:45 +0000 (UTC)
Can't recommend any particular reference material, but any good book, DVD etc. 
on body work would likely help. Also, shows like 'Muscle Car,' 'Extreme 4X4' 
and, yes, 'American Chopper' can also give a few good tips now and then. 

For the sills and outrigger, you have to make sure the new are aligned with a) 
the remaining structural components and b) the door and door bulkheads. The 
best way to attach the sills--IMO--is with plug (aka 'rosette') welds. You'll 
need a MIG--could be done with gas--and you'll want to use a higher voltage 
setting than you'd probably expect to get penetration on the flat surface. I 
have a DVD showing how to do good plug welds--the main 'tip' is to start the 
weld on the edge of the hole, not on the flat underlying surface. Then, grind 
the weld flat and if you want use a flat-tipped punch of appropriate size to 
dimple the weld to simulate a spot weld (optional). 

The other welds should be butt welds. Measure, measure, measure and cut. If 
possible, bevel the edges of the metal to be joined. Measure and adjust. Then 
with the parts aligned and held firmly tack them together every few inches. 
Measure and adjust. Fill in between the tacks with short, intermittent welds up 
to about a half-inch, 'backfilling' the welds to avoid preheating the metal. 
Cool with a blast of air. Measure and adjust ... Grind and sand. Paint. 

Tools required: 
- air compressor (can use electric tools instead) 
- air cutoff tool (3" preferred) 
- angle sander (I like 3", can use 4.5" electrical for larger areas). Flap 
disks OK and/or grinding wheels 
- MIG welder (gas, if you prefer) 
- body hammer and dollies 
- clamps (vise-grip-like C-clamps good--available cheap at Harbor Freight) 
- measuring tools and MkI eyball 


bs 

-------------------------------- 
Bob Spidell - San Jose, CA 


Hi I getting started on rebuilding my 57 BN4. 
I have been looking in the archives and elsewhere 
for some material on how to replace the sills and 
at least one outrigger. I haven't found any good 
info on how to. Any suggestions on where to look. 
thanks for any help. 
Vern 
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>