I once used the Eastwood system and at first everything seemed to work well.
However the stuff doesn't seem to stand up very well at all over time.
Trouble is, somebody put my initial positive report on ther web site and
it's been there ever since. I can't remember where I ran across this, but
please remove it from your site.
I have been using a local industrial zinc plater for the last few years with
excellent results. You should be able to find one in your area.
Rich
----- Original Message -----
From: "john spaur" <jmsdarch@sbcglobal.net>
To: <healeys@autox.team.net>
Sent: Tuesday, September 01, 2009 12:44 AM
Subject: [Healeys] small parts plating
> Does anyone (especially Bob Haskell - I read your 2006 post) have any
> update on the Eastwood Tin Zic plating system?
>
> I recall reading a post stating that someone's parts were developing black
> spots but I never say any follow up to determine if it was a problem with
> the kit or perhaps application issues.
>
> John
> '62 BT7 and thinking about the plating issues
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|