My newly installed doors are looking pretty good considering were they were 6
years ago.
However one door will only open from the outside latch. The inside door
mechanism needs
a skosh more pull to release the door latch. Theres only 3 parts here, the
door handle unit,
the latch unit and the flat bar that connects these 2 units.
I don't see any obvious wear on these parts and there really isn't any room
for adjusting the
front and rear door mechanisms that I can see. They are secured directly to
the door by machine screws.
Any suggestions on what or where I can adjust to take up the slack.
Thanks Mark
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|