Healey,
Why was my response rejected?
Marks 3
On Aug 13, 2009, at 8:46 AM, healeys-bounces@autox.team.net wrote:
> The results of your email command are provided below. Attached is your
> original message.
>
>
> - Unprocessed:
> I checked the February 2007 "Originality Guide for Restorations and
> Registry Inspections - Austin Healey 100, 100-Six, 3000 Models"
> and
> found the following guidance:
> 1. Gear Shift carpet hole - "Carpets are unbound at the edges
> except
> the area around the gearshift from BN2 to BJ7.......BJ8's are
> unbound
> due to the fitment of a console."
> 2. Handbrake carpet area - "The cutout for the emergency brake
> cutout is NOT bound on Longbridge BN4, centershift BN/BT series,
> BJ7
> or BJ8."
> 3. Gearbox dipstick flap in carpet - I found no answer to this
> problem
> in the Guide. However, following my recent rebuild of the gearbox,
> overdrive and drive line I cut a flap in my carpet. I decided that
> convenience overrides originality on my BJ8. While I had the
> tranny
> tunnel out of the car during the project I laid the tranny carpet
> on
> top of the fiberglass tunnel and used the dipstick access port as a
> template and marked the underside of the carpet, Then, I used a
> carpet knife to cut a flap. This is very much better than trying
> to
> fold the carpet back behind the radio and console when it is time
> to
> check or refill the tranny/OD oil following routine oil change.
> Marks 3
> '66 BJ8
>
> - Ignored:
>
>
>
> - Done.
>
>
> From: Mark Schneider <mandmschneider@comcast.net>
> Date: August 13, 2009 8:46:09 AM PDT
> To: healeys-request@autox.team.net
> Subject: Healeys] BJ8 carpet questions
>
>
> Greetings,
>
> I checked the February 2007 "Originality Guide for Restorations and
> Registry Inspections - Austin Healey 100, 100-Six, 3000 Models"
> and found the following guidance:
>
> 1. Gear Shift carpet hole - "Carpets are unbound at the edges except
> the area around the gearshift from BN2 to BJ7.......BJ8's are
> unbound due to the fitment of a console."
> 2. Handbrake carpet area - "The cutout for the emergency brake
> cutout is NOT bound on Longbridge BN4, centershift BN/BT series, BJ7
> or BJ8."
> 3. Gearbox dipstick flap in carpet - I found no answer to this
> problem in the Guide. However, following my recent rebuild of the
> gearbox, overdrive and drive line I cut a flap in my carpet. I
> decided that convenience overrides originality on my BJ8. While I
> had the tranny tunnel out of the car during the project I laid the
> tranny carpet on top of the fiberglass tunnel and used the dipstick
> access port as a template and marked the underside of the carpet,
> Then, I used a carpet knife to cut a flap. This is very much better
> than trying to fold the carpet back behind the radio and console
> when it is time to check or refill the tranny/OD oil following
> routine oil change.
>
> Marks 3
> '66 BJ8
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|