This is not uncommon behavior of these types of speedo's. Possibly some
solidifying of the oil in the spindle bearing. It can make the needle
bearing stick a bit when starting of. It will do no harm whatsoever.
Best to just leave well alone but if you cannot live with it, just try
to add some clock oil to the bearing using a pointed wooden tooth pick.
Just wet the bearing, a full drop of oil is way to much.
Kees Oudesluijs
R. Price Lindsay schreef:
> First I would like thank all those listers that have helped me out
> over the last month or so-it's really appreciated! I hate to be a
> pain in the rear but I have, I hope, one final question.
>
> I put my second angle drive with washer and a new cable on my BJ 8
> this morning and took it for a drive. The readings were smooth without
> any jump in the needle at slow or fast speeds. My only question/issue
> is the speedo does not read anything until about 20 mph. At that point
> it works like a charm. When I slow down below 20 mph it reads
> perfectly. Once I stop and start again it doesn't read until 20 mph
> and then it's fine.
>
> My question has two parts 1) has anyone had a similar experience or
> have any ideas on why this would be happening and what a fix would be
> and 2) before I take off for a long drive am I running a risk of
> breaking another angle drive??
>
> Thank you again for your valuable insight.
>
> Price Lindsay
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|