I am trying to install the lower grille strip on my BT7. I am getting some
serious interference
from behind because of the pop rivets that hold on the lower grille brackets.
What needs to be done here, bend out the strip a little in these three areas
or try and grind down the back of the rivets
and hope they still secure the brackets in place when I'm done. I assume my
choice of
pop rivets were a little on the long side. Other than that I don't see how
the factory fit
this piece on without the rivet interference.
Man, ya think the reassembly is going to be a piece of cake. Can't wait to
try and slip that
grille in from the side and fit it up.
Mark
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|