Tom -
Behind the back plate. Offhand the spacer would be rectangular, about
1/2" by 1" by about 1/8" or something similar to that.
The set screw is a slotted countersunk BSC or BCY thread (not sure
which). Actually to correct myself I don't think it is BSC (british
standard coarse) but actually BCY (British Cycle Thread), although the
threading is so short probably any coarse thread screw of a similar
diameter will work in there.
Alan
On 8/1/09, tomfelts@windstream.net <tomfelts@windstream.net> wrote:
> Are you saying that a spacer fits in the hole where the threaded ring is or
> under the chrome back plate itself?
>
> Thanks
> Tom
> ---- Alan Seigrist <healey.nut@gmail.com> wrote:
>> Tom -
>>
>> There should be a spacer between the back of the lock and the chrome
>> finisher plate on the inside of the door, so yes what you did is
>> correct. I used a teflon fender washer I bought at home depot and cut
>> it to fit accordingly.
>>
>> Also it helps to have the little BSC set screw on the bottom of the
>> chrome cylinder, but not totally required if missing.
>>
>> Alan
>>
>> On 8/1/09, tomfelts@windstream.net <tomfelts@windstream.net> wrote:
>> > That's not the problem. It works like a charm. the problem is when I
>> > mount
>> > it flush with the door, it is squeezed so much that it can't move.
>> > Loosening the front knob allows it to move freely but then I have a
>> > loose
>> > lock. I have added a rubber spacer under the front knob and now it
>> > works
>> > nicely. I was wondering if there was a spacer under it originally.
>> >
>> > Thanks
>> > tom
>> > ---- 63ahbj7 <63ahbj7@comcast.net> wrote:
>> >> <<A (small) shot of graphite powder into the key slot is perhaps
>> >> better. Grease will eventually attract dust and dirt and get
>> >> gunky--could stop the tumblers from falling properly. >>
>> >>
>> >> Bob is 1000% correct, Tom. Better take it apart & clean - again<G>!!
>> >>
>> >> Ed
>> >> _______________________________________________
>> >> Support Team.Net http://www.team.net/donate.html
>> >>
>> >> Healeys@autox.team.net
>> >> http://autox.team.net/mailman/listinfo/healeys
>> >>
>> >> You are subscribed as tomfelts@windstream.net
>> >>
>> >> http://www.team.net/archive
>> > _______________________________________________
>> > Support Team.Net http://www.team.net/donate.html
>> >
>> > Healeys@autox.team.net
>> > http://autox.team.net/mailman/listinfo/healeys
>> >
>> > You are subscribed as healey.nut@gmail.com
>> >
>> > http://www.team.net/archive
>> >
>>
>>
>> --
>> Alan
>>
>> '52 A90
>> '53 BN1
>> '64 BJ8
>
>
--
Alan
'52 A90
'53 BN1
'64 BJ8
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|