Listers,
Can anyone tell me the bolt diameter, length, thread pitch/count for
the two bolts associated with the "blanking plate" area on the forward
right side of the engine. The Healey models in question are BN7, BT7,
BJ7, and BJ8. This hardware may be seen on pages 10 & 11 of the Moss
catalogue AHY-104 under page heading "External Engine 100-6, 3000".
The bolt is item 39, two are required. Also listed are four (4)
copper washers, item 40.
On earlier Healey engines, i.e., BN4 & BN6, a blanking plate, gasket,
studs, nuts, and washers served to seal an area of the block. On the
later cars the bolts apparently sealed the threaded holes and the
plate was no longer necessary. We are about to fire up a rebuilt
engine and do not have the bolts or the technical information on the
bolt size, length, or threads and are hoping one of the listers can
provide the information.
Thanks.
Marks 3
'66 BJ8
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|