The inner speedo cable is kinked. Pull the cable out of the housing
and lay it on a table. Then roll it and you should see where the kink
is when that portion of the cable pops up or makes the cable hop.
You will need to replace the inner cable.
John
At 10:09 AM 7/27/2009 -0500, Ron Ray wrote:
>Richard,
>
>My speedometer bounces at every speed even after being rebuilt by MOKAN
>twice.
>Hopefully someone on this list can help us both with this problem.
>
>Ron
>
>-----Original Message-----
>From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
>On Behalf Of Richard Kahn
>Sent: Monday, July 27, 2009 9:52 AM
>To: warthodson@aol.com; bspidell@comcast.net; price@advocateadvisors.com
>Cc: healeys@autox.team.net
>Subject: Re: [Healeys] Spedo/Cable/Angle Drive - BJ8
>
>Can anyone suggest a solution/cause to the needle bouncing all over the
>place
>at about 50 mph but not at 70+ or less than 40? It does this often but
>sometimes it behaves. The speedo was rebuilt 8K ago. I think it always has
>done this. Seems to be accurate according the GPS.
>Rich (yea, another Richard) Kahn
>_______________________________________________
>Support Team.Net http://www.team.net/donate.html
>
>Healeys@autox.team.net
>http://autox.team.net/mailman/listinfo/healeys
>
>You are subscribed as jmsdarch@sbcglobal.net
>
>http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|