I need to remove and replace the A-pillar face plate; just the upper portion.
The replacement part tucks up under the inner scuttle top panel. What
should I do to bend the scuttle flange up then back down again? I
think I need to heat it, but I am not sure of the heating and cooling
process so as to not damage the metal.
I check the archives and around the Internet but did not find what I needed.
Help from the list would be very much appreciated.
Thank you,
John
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|