healeys
[Top] [All Lists]

Re: [Healeys] Rear Brake Problem

To: buhler@memphisassociates.com
Subject: Re: [Healeys] Rear Brake Problem
From: Bob Spidell <bspidell@comcast.net>
Date: Tue, 21 Jul 2009 16:30:44 +0000 (UTC)
re: " any suggestions about installing these on the reat brakes." 

- observe current installation (take picture if necessary) 
- clean all internal parts thoroughly with brake cleaner 
- back out the adjusting screw--collapse the adjuster wedges--all the way 
- get new felts for the standoff pillars if necessary 
- put a drop of heavy oil or light grease on the end of the felts 
- install the springs--there's some evidence the original springs are different 
lengths, but replacements are the same. If yours are different lengths refer to 
the shop manual for correct placement 
- make sure the shoe ends are 'opposite'--i.e. there's a square hole on one end 
for the 'hook' on the slave cylinder and a solid end on the other--make sure 
the solid end butts against the backside of the cylinder (someone on the BCF 
had 'hole-to-hole' and it caused binding ) 
- install the new shoes with springs and make sure the lining surface is 
orthogonal to the backplate (not sure what the scientific method is to 
accomplish this--I use a carpenter's square and mark one eyeball) 
- make sure the shoes are centered; i.e. the lining edges are equidistant from 
the edge of the backplate all around 
- clean all internal parts thoroughly with brake cleaner and wipe down the 
shoes with clean cloth 
- clean inside of drum and install 
- adjust with parking brake off (maybe even detach the cable--I don't and 
haven't had any issues) 


bs 




I reported earlier about a driver side rear brake problem on my 67 3000. When 
backing up, the brake would tighten up. Went away when driving forward. Had 
not used the foot or emergency brake prior to this. Removed the drum and 
found that part of the brake shoe lining had fallen off the shoe and was 
lodging in between the remaining shoe liner and drum. Cleaned out the liner 
pieces and works fine now. 

Ordered a set on new brake shoes and was 
wondering if there are any suggestions about installing these on the reat 
brakes. 

Thanks, 

Jon 
_______________________________________________ 
Support Team.Net http://www.team.net/donate.html 

Healeys@autox.team.net 
http://autox.team.net/mailman/listinfo/healeys 

You are subscribed as bspidell@comcast.net 

http://www.team.net/archive 
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>