We're restoring a BN2/100M. I didn't see any evidence of any spacers anywhere
when we disassembled the car. I believe the 100s did not originally have a
heat
shield above the muffler (ours had no shield, holes or captive nuts). The Moss
catalog confirms this (FWIW). We may add one.
I haven't found the thick washers anywhere. We're short one or two, and if we
can't find them there are fender washers that are too thin but otherwise
dimensionally very close. Two of them stacked are close to one thick washer in
thickness.
Bob
Thomas Willig wrote:
> Were are the 1" square spacers on the "asbestos" heat shield on the BN2
> used:
>
> On all pieces?
> No spacers at all?
> Only on the shield above the muffler?
>
>
>
> Were can I get the big washers with only a 3/16" center hole which are
> used to attach the heat shield to the body?
>
>
>
> Thanks
>
>
>
>
>
> Thomas Willig
--
*******************************************************************
Bob Spidell San Jose, CA bspidell@comcast.net
*******************************************************************
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|