Rich, I just measured again and still came up with 29" Are you measuring from
the very bottom of the sump or from the sump directly under the "T". Maybe I
have one of the rare "deep sump" pans from the Cape?
Regards,
Rick
--- On Sun, 7/5/09, Rich C <richchrysler@quickclic.net> wrote:
From: Rich C <richchrysler@quickclic.net>
Subject: [Healeys] Fw: healey motor/gearbox measurements
To: "Healeys" <healeys@autox.team.net>
Date: Sunday, July 5, 2009, 11:15 PM
Rick, et al,
I thought I was losing my mind so I just went out and checked the heights on
a
26D series and a 29K series and used a straight edge across the bottom of the
pan on each engine (both engines are sitting in stands) and measured to the
top of the T breather pipe. Both measured within 3/16" of 27" total height.
Variation was due to one of them having the T pipe screwed in a bit further
than the other.
And that's measurements taken using the Queen's Imperial measuring system.
Rich
----- Original Message -----
From: HealeyRick
To: Linwood H Rose ; healeylist ; Rich C
Sent: Sunday, July 05, 2009 3:12 PM
Subject: Re: [Healeys] healey motor/gearbox measurements
On my 29Dthe height from the lowest part of the oil pan to the top of
the T was more like 29", everything else matches Rich's dimensions. Perhaps
Rich was measuring height in Canadian inches and I was measuring in American
inches?
Rick
Lin,
A couple of weeks ago a good portion of the list members were
heading to Conclave!
- height from bottom of oil pan to top of T pipe on rocker cover
27"
- length from fan centre to engine back plate 33 1/2"
- length from fan centre to end of propshaft on gearbox/od 64"
- Width from distributor across to air cleaners approx. 25".
Rich Chrysler
----- Original Message ----- From: "Linwood H Rose"
> Hi folks
> I posted this a couple of weeks ago without a response. Thought I
would try one more time before I give up. Thanks!
>
>
> Does anyone have linear measurements for the engine with usual
components attached? Or, if there is a document like the frame "blueprint"
you can refer me to, I would appreciate it. I am looking for things like
height from bottom of oil pan at lowest point to the top of the rocker cover
(or the vent "T" pipe on the cover), depth from fan center to engine
backplate, depth from fan center to end of the gearbox, width of the block
and width from the air cleaners to the distributor (widest point of the
assembly)
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
You are subscribed as healeyrick@yahoo.com
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|