Tom... Check our Rare and hard to Find Parts Catalog on page 39 "
Lever Bolt "
catalog can be down loaded ... Norman Nock
--- On Fri, 6/5/09, Mr. Finespanner <mrfinespanner@earthlink.net> wrote:
From: Mr. Finespanner <mrfinespanner@earthlink.net>
Subject: [Healeys] shifter roll pins
To: tomleavy@comcast.net
Cc: "healey list" <healeys@autox.team.net>
Date: Friday, June 5, 2009, 6:35 PM
Tom,
BJ8 dowel bolts will work fine in place of roll pins, and the roll pin holes
are the
right size for a 1/4-28 tap. Unfortunately I don't know of any ready source
for the
dowel bolts, but they should be possible to find--British Car Specialists
might be
a good place to look first. They are also easily fabricated from regular 1/4"
bolts.
regards,
Doug Reid, 18G Motorworks
Message: 3
Date: Fri, 5 Jun 2009 01:38:47 +0000 (UTC)
From: tomleavy@comcast.net
Subject: [Healeys] Early Centre Shifter Lever roll pin trouble
To: healeys@Autox.Team.Net
Message-ID:
<2089424595.918011244165927622.JavaMail.root@sz0089a.westchester.pa.mail.comc
ast.net>
Content-Type: text/plain; charset="us-ascii"
Hi Listers
My BJ7 shift lever is acting up. I installed new roll pins, but realized that
one of the pins jumped out. Of course, the shifter and bronze bushing jumped
out. What size do I need (diameter and length), and has anyone modified a MKI
shifter tith a blot like the MKIII's?
If I use the roll pins, how far should I drive them so that they hold the
shifter in its proper place?
Thanks.
Tom
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
You are subscribed as sjnnock@sbcglobal.net
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|