I have exactly the same problem and the loop has been tried both ways. The
tach works fine on a bench test. It's a fresh rebuild done by Nissongers.
It's got an excellent earth which has been confirmed. The wiring has proper
continuity.
Rich Chrysler
----- Original Message -----
From: "David Nock" <healeydoc@sbcglobal.net>
To: <healeymanjim@hansencc.net>
Cc: <healeys@autox.team.net>
Sent: Thursday, May 28, 2009 3:29 PM
Subject: Re: [Healeys] inop tach
> The loop needs reversed
>
>
>
>
> David Nock
> British Car Specialists
> Stockton Ca 95205
> 209-948-8767
>
> www.britishcarspecialists.com
> .
> .
>
> On May 28, 2009, at 12:07 PM, <healeymanjim@hansencc.net> wrote:
>
>> my brother just put a new wiring harness in his bj8 and the tach
>> will not work. works fine in another bj8 so it is some kind of
>> wiring anomoly. the loop goes around the post correctly,(at least
>> it is like mine) and is grounded . any ideas? hjim
>> _______________________________________________
>> Support Team.Net http://www.team.net/donate.html
>>
>> Healeys@autox.team.net
>> http://autox.team.net/mailman/listinfo/healeys
>>
>> You are subscribed as healeydoc@sbcglobal.net
>>
>> http://www.team.net/archive
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler@quickclic.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|