Also turn the camwheels in the wheel boxes 180:. This will give you an
unworn part of the wheel in action, causing less play on the wiper arms.
Kees Oudesluijs
NL
randy pole schreef:
> Mark
>
>
>
> I found the same problem and found it a lot easier to loosen the tube nut
> which can give you some adjustment, also if you take the wheelbox covers off
> you will find there is 2 slots on each side that the tube shoulders can sit
> in, so again you have a little adjustment there.
>
>
>
> I also found that the looking down the hole thru the shroud and bulkhead top
> were slightly out of line before I put the spindles thru, so filed the one.
>
>
>
> Make sure the wheelboxes are the right way up also, off the top of my head I
> cannot remember, but search the archives, good old Rich replied to my question
> on which way up.
>
>
>
> cheers Andy
>
>
> _________________________________________________________________
> View your Twitter and Flickr updates from one place Learn more!
> http://clk.atdmt.com/UKM/go/137984870/direct/01/
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as coudesluijs@chello.nl
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|