Looks to be the same type of gasket that's being sold for the the exhaust
manifold to downpipe flange--these are barely adequate for exhaust, but would
be
OK durability-wise for intakes. Seem a bit thick to me.
All suppliers are specifying 4 gaskets total; nothing about a gasket between
the
insulator block and the manifold. I gotta believe you need something there.
Bob
andy pole wrote:
> Bob
>
> This is the metal (and only) gasket that is listed in the parts book for
> the HD8's:
>
> http://www.ahead4healeys.co.uk/productspec.aspx?StockCode=FL4630
>
> if memory serves correct, it and the insulator block are shown on the
> drawing with the air cleaners on, cannot check the page, as at work at
> the moment.
>
> cheers Andy
>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell@comcast.net
*******************************************************************
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|