I wrote earlier about replacing the flexible hose to the clutch slave
cylinder and was having trouble getting to the bleed valve. Options were to
remove the tranny cover or the slave cylinder. Could not get to the top bolt
on the slave cylinder so before removing the cover, I found a short,
angled, 7/16" ratchet wrench that I could barely slide over the bleed screw.
Only room for one click on the wrench but was able to turn the screw enough
to bleed the system. Fortunately, the screw was not frozen in place. Hope
this may help anyone else with the same problem. Thanks again for your
suggestions.
Jon
**************Feeling the pinch at the grocery store? Make dinner for $10
or less. (http://food.aol.com/frugal-feasts?ncid=emlcntusfood00000001)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|