Kees,
The way I did it before with other engines was simply to buy next oversize
bearings and have my shop do the crankshaft for this set of bearings - what
do you mean by swapping shells to get the best tolerances???.. Are the
bearings sold not equal??
Best, Tadek
-----Original Message-----
From: Oudesluys [mailto:coudesluijs@chello.nl]
Sent: 11 lutego 2009 22:02
To: Tadeusz Malkiewicz
Cc: healeys@autox.team.net
Subject: Re: [Healeys] crankshaft bearings - what make to look for?
I am not so sure if there are great differences in quality between the
bigger brands, but Vandervell is regarded as one of the best for British
cars. However the main thing is that you choose the tolerances and
surface finish of the crankshaft properly and measure the play of each
journal with plastigauge. Go near the tight end of the tolerances given.
You may have to swap shells to get all tolerances as equal as possible.
Same with camshaft, but not so critical.
Kees Oudesluijs
Tadeusz Malkiewicz schreef:
> Hello,
>
> I am beginning to look for cam, crankshaft & rod bearings for my 100
engine
> rebuild. I am wondering what brand to look for, what is the best.
>
> All advice is appreciated...
>
> Also, I am wondering is everybody is selling the same gasket kits for the
> engine or there are also different makes and some are a better choice?..
>
> Thanks,
>
>
> Tadek
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as coudesluijs@chello.nl
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|