healeys
[Top] [All Lists]

Re: [Healeys] 100 Mystery

To: Bob Spidell <bspidell@comcast.net>
Subject: Re: [Healeys] 100 Mystery
From: John Harper <ah@jharper.demon.co.uk>
Date: Sun, 8 Feb 2009 08:29:20 +0000
Bob

You should have a square plate approx. 6" x 3=" with the corners
removed. The edges are turned in slightly to produce an approximate ="
bevel on all four sides. There are holes top and bottom centre to take.
I believe, 10-32 screws. A layer of felt is fitted under this plate to
seal the edges.

I believe that this plate was also fitted to Austin A40 and A70 saloons
but I doubt that this information will help you.

You should be able to find this part in the A-H parts list under floor
fittings. Blanking plate  14B 2654
Felt   14B2655

Regards
>
>My dad and I are reassembling our 100M. We have a puzzle I'm hoping
>someone might be able to help with: on our LHD car, there are 2 round
>holes where the brake and clutch pedals go through. Where the holes are
>is a raised part of the floorboard, and on the outside (engine bay
>side) are a couple of thread insert-type nuts. On the passenger side,
>it's clear these nuts are for a blanking panel with a felt seal, but it
>seems there should be something on the driver's side but we can't find
>a part nor a reference to it in the (Moss catalog). Does anyone know
>what, if anything, goes around the clutch and brake holes? There are
>small plates on the pedals on which rubber pads ('draft excluders') go,
>but these don't come near to sealing the 2 round holes (they don't come
>all the way up to the floorboard, either). It sure seems like there
>should be some sort of panel to help seal up the area around the
>pedals--anyone know what goes there?
>

--
John Harper
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>