healeys
[Top] [All Lists]

Re: [Healeys] Gear reduction starter installation saga continues

To: <fortee9er@yahoo.com>, healeys <healeys@autox.team.net>
Subject: Re: [Healeys] Gear reduction starter installation saga continues
From: richard mayor <mayorrichard@hotmail.com>
Date: Wed, 4 Feb 2009 02:12:37 +0000
They make nyloc nuts that are thinner than a standard size nut - and then you
would not need a lockwasher. Richard
 > Date: Tue, 3 Feb 2009 17:56:29 -0800> From: fortee9er@yahoo.com> To:
healeys@autox.team.net> Subject: Re: [Healeys] Gear reduction starter
installation saga continues> > I spent the afternoon tinkering with the
starter and got it clocked so that it cleared the passenger toe box and the
engine block. The top bolt no problem but the bottom bolt not so good there is
very little room for the nut to fit between the starter motor and and the
mounting tab. I should clarify that the nut will just fit but not the nut and
the lock washer. I am thinking of finding a thinner nut that will fit with the
lock washer. Any ideas suggestions would be greatly apprciated.> Jorge Garcia>
1965 BJ8> _______________________________________________> Support Team.Net
http://www.team.net/donate.html> > Healeys@autox.team.net>
http://autox.team.net/mailman/listinfo/healeys> > You are subscribed as
mayorrichard@hotmail.com> > http://www.team.net/archive
_________________________________________________________________
Hotmail. goes where you go. On a PC, on the Web, on your phone.
http://www.windowslive-hotmail.com/learnmore/versatility.aspx#mobile?ocid=TXT
_TAGHM_WL_HM_versatility_121208
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>