If your going to push the envelope, you should probably have a sonic test
done to ensure that there is enough "meat" to achieve this......you want to
have at least 180" left over so that you get good heat distribution as well
as room to bore out again if required.
The sonic test will also tell the machinist to offset the bores if necessary
to center the bores.
Paul
-----Original Message-----
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of keith taylor
Sent: Wednesday, January 28, 2009 1:21 PM
To: healeys
Subject: [Healeys] A70 Motor rebore to 100
Are there any issues reboring an A70 motor (2.2 lt) out to 100 spec. 3.43"
Q1 Is there enough "meat" in the bore to do this ?
Q2 Any other pitfalls apart from no tacho. drive
Keith Taylor
Wamberal OZ
BN1
BN2
100M....if I ever finish them
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
You are subscribed as britishcars@shaw.ca
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|