----- Original Message -----
From: "Rich C" <richchrysler@quickclic.net>
To: <healeys@autox.team.net>; <info@atteanlodge.com>; "andy pole"
<ampole@hotmail.com>
Cc: "John Sims" <ahbn6@verizon.net>
Sent: Friday, January 23, 2009 10:25 AM
Subject: Re: Boot Trimming, was[Healeys] trunk woes
> Armacord trunk installation in BJ8 Part 2
>
> The small piece of rectangular Armacord fits onto the vertical bulkhead
> immediately in front of the battery. The bound edge will fit to the right
> to
> result in a finished edge where it meets the right side panel. You'll need
> to determine where the battery cable will go through the bulkhead and make
> a
> hole for it. Originally they simply cut an X to run the cable through.
> Once
> fit dry and everything lines up nicely, glue is applied to both surfaces
> and
> the piece is installed. If it's too wide, you can either trim the left
> unfinished edge or simply wrap it around the edge of the bulkhead. This
> will
> eventually be covered by the black hardboard fuel filler neck panel.
> The left and right lower floor well pieces should be trial fitted dry to
> familiarize how they fit. These will be glued onto the lowest floor area
> and
> forward onto the trunk box sections. The fully bound edges will face
> outboard and to the rear, clearing the rear bumper bar and support strut
> to
> the left and right sides respectively. Of course the right piece will have
> to be worked under the battery support brackets too. The main trunk wiring
> harness will be fitted under the left piece, and the rear ends of these
> pieces will need to be fussed with to clear the tail lamp wiring.
Part 3 to follow
Rich Chrysler
[demime 1.01d removed an attachment of type image/jpeg which had a name of
Convertible Detail 0014.jpg]
[demime 1.01d removed an attachment of type image/jpeg which had a name of
Convertible Detail 0010.jpg]
[demime 1.01d removed an attachment of type image/jpeg which had a name of
Convertible Detail 0011.jpg]
[demime 1.01d removed an attachment of type image/jpeg which had a name of
Convertible Detail 0012.jpg]
[demime 1.01d removed an attachment of type image/jpeg which had a name of
Convertible Detail 0013.jpg]
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|