Brad
Here a few pics which may help, as far as I have got:
I used a 3M spray contact adhesive from local car accesory shop, sprayed
liberally on both metal and armacord. I had new inner wings so firstly drilled
the holes for the left wood block to hold spare wheel and also for the battery
rail on right hand side.
Firstly fitted the left hand wheel arch cover:
http://www.austin-healey3000.com/apps/photos/photo.jsp?photoID=15670155&prev=
1
then fitted the right hand side onto battery flat and filler panel:
http://www.austin-healey3000.com/apps/photos/photo.jsp?photoID=15670156
then fitted the left hand side flat panel and small floor pieces left and
right(scroll down page):
http://www.austin-healey3000.com/thejigsaw.htm
thats as far as I have got, was going to fit the long panel under the rear
shroud lip, was hoping someone could send me a pic showing that I assume it
goes under the trunk lock support and I guess must be slotted for the tank
straps. I have also seen pictures of it just laying over the left hand frame /
shroud extension. Rich, and chance you could clarify please?
The back panels look pretty straight forward just been concentrating on the
rest before engine goes in.
Hope this little helps to give you some idea.
Andy
_________________________________________________________________
Cut through the jargon: find a PC for your needs.
http://clk.atdmt.com/UKM/go/130777504/direct/01/
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|