I get 11/32in or 8.8mm for a brand-new, "QH" brand disk.
I assume you're asking for the (total) thickness of the friction material.
Bob
rjhco wrote:
> Anyone know the original, unused cross section dimension of the BJ8 clutch
> friction material, either one side or both together?
>
> Thanks in advance.
>
> Best regards,
> Jim Hockert
> Dallas, TX
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as bspidell@comcast.net
>
> http://www.team.net/archive
>
>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell@comcast.net
Failure is the opportunity to begin again more intelligently. -
Henry Ford
*******************************************************************
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|