Hi Earl,
I installed a servo uinit from BPN ( I think it was a Powertune a Lockheed
knock off ) on my 66 BJ8 a couple of years ago , so far so good..... I made
it a lot harder for myself by not wanting to drill new holes in the toe
board and not to use the mounting hardware that came with the unit. I
fabricated mounting brackets to mount the BPN servo on to the factory
bolts........
Cheers
Kenny
----- Original Message -----
From: "Earl Kagna" <kags@shaw.ca>
To: "Healey List" <healeys@autox.team.net>
Sent: Thursday, January 15, 2009 9:04 PM
Subject: [Healeys] Servo correction!
> Gentlemen:
>
> The servo that I asked about is a 'Powertune' not Powerboost. Too much
> Vodka tonight!
>
> It's on the British Parts Northwest web-site. BPN is in Oregon - Portland
> area.
>
> Earl Kagna
> Victoria, B.C.
> BT7 tri-carb
> BJ8
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as geatros@shaw.ca
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|