I think the wholes in the frames are different, depending on the modell. I am
just working on the frame of my 62 BT7 MK2. The usual distances between the
wholes for the battery cable and the wiring harness are about 11 inches
(27cm). But on the wiring harness side there are also holes in-between these.
It seems not all where used to fix the clips. About 3 or 4 were without any
use as far as I can see on my frame. So also for me it would be really helpful
to get a template or whatsoever to know which holes where for the clips
screws. The diameter of the wholes on my car is about 3.5 mm.
Thanks
Josef Eckert
Konigswinter/Germany
54BN1, 62 BT7, 65 Sprite
-----Urspr|ngliche Nachricht-----
Von: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net] Im
Auftrag von John McElrath
Gesendet: Mittwoch, 17. Dezember 2008 17:53
An: Rick Swain
Cc: Healey List
Betreff: Re: [Healeys] Holes in Frame Rails
I would appreciate the same information along with the distance between them
and the inside rail corner so I can put them in the proper place. My new
frame doesn't have them either and the original frame has more holes than
Swiss cheese.
Thanks
John
61 BN7 MK II
On Wed, Dec 17, 2008 at 10:45 AM, Rick Swain <rjswain@hotmail.com> wrote:
> Can anyone tell me the sizes of the holes drilled in the frame rails
> for mounting clips for wiring harness, battery cable, fuel and brake
> lines? My new frame has none and I don't think any of the ones in the
> old frame are the right size.ThanksRick '59 BN4
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|