David,
If it is like the "Mk I", then the hood grill is installed from the front -
it slips into the opening in the hood and the top piece fits from the top,
the three threaded studs going through the hood, then through the top of the
grill and are fastened with flat and spring washers and hex nut.
Mirek
----- Original Message -----
From: "David Schweninger" <quenty@ntelos.net>
To: "Healey Mail List" <healeys@autox.team.net>
Sent: Thursday, August 28, 2008 4:59 PM
Subject: [Healeys] Bonnet Grill Help !
> Hello all.
> It's my understanding that the bonnet Grill in my BN7 II installed
> from the inside (backside) by hooking the lower edge of the grill over
> the turned up flange on the bonnet. and then rotating the grill
> forward and up into the Bulge.
>
> Coming from the back The Grill ends won't allow me to push the grill
> far enough forward to hook over flange.
>
> What am I doing Wrong?
>
> Dave and Daisy
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as m.g.sharp@sympatico.ca
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|