It seems to me that the electronic ignition company should reduce the height
of the magnet sleeve so that they fit intended distributors.
Ned Paulsen
1960 BN7
In a message dated 8/28/2008 5:01:39 P.M. Eastern Daylight Time,
price@advocateadvisors.com writes:
Wouldn't you think someone would make quality rotor that would accomodate
the dimentions of an electronic ignition without having to go to your shop and
grind it?
------Original Message------
From: Dan
Sender: healeys-bounces+price=advocateadvisors.com@autox.team.net
To: healeys@autox.team.net
Sent: Aug 28, 2008 2:38 PM
Subject: Re: [Healeys] Rotors - it happened ....
If you are using a Pertronix system, you need to grind down the rotor so it
sits farther down on the shaft. I have seen a few dizzy's where rotors were
not taken down and there is a lot of black dust inside the dizzy. I saw one
where the center electrode was completely worn away. Dan Serrao1963 BJ7
_________________________________________________________________
Get ideas on sharing photos from people like you. Find new ways to share.
http://www.windowslive.com/explore/photogallery/posts?ocid=TXT_TAGLM_WL_Photo
_Gallery_082008
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
You are subscribed as price@advocateadvisors.com
http://www.team.net/archive
Sent via BlackBerry by AT&T
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
You are subscribed as npaul72464@aol.com
http://www.team.net/archive
**************It's only a deal if it's where you want to go. Find your travel
deal here.
(http://information.travel.aol.com/deals?ncid=aoltrv00050000000047)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|