Price,
I did this many years ago. Used a combination of C clamp with wood block and
tapping on the wood block. Soaking the bush with oil suggested by someone is
probably a good idea. Worked out fine but I did have to do a good bit of
sanding on the inside of the bush once installed to get the shaft in. Used a
large wood dowel covered with 300 and then 600 grit paper as I recall.
Keith Pennell
> Can I "press" the bronze bush into place with a large C clamp or is there a
>better way. I thought about a hammer and flat piece of steel bar as well.
>When I removed the old one it seemed a little fragile which gives me pause.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|