If we know the thread count, we could prolly figger it out, eh?
Wilko
On Aug 7, 2008, at 3:17 PM, Freese, Ken wrote:
> The nominal setting for the jet position is 2 1/4 adjusting screw
> turns
> from a flush jet position. I need to know what this equates to in
> inches. .050 or .086 or what?? I think I read .086 in a book
> somewhere,
> but I can't find it now.
> Thanks,
> Ken Freese
> 65 BJ8
> _______________________________________________
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|