Al,
These pictures show the choke cable setup on my BN7. The main cable
from the dash is a standard repro.
I made the cables to the carbs.
They are all standard motorcycle throttle parts. This consists of
the Black Sleeving, the End Caps for the sleeving, the 1/16" stranded
(7X19) Cable, and the Ferrel which is soldered on to the upper end of
the cable.
An older motorcycle shop will have all the parts. The newer shops tend
to be like Kmart ,with complete assemblies in little plastic bags.
Good luck
Dave and Daisy
This shows the sleeving pulled back. Note the end cap. Also the ferrel
is just visible on the brass barrel.
This shows the Ferrel which has a small cup on the large end. the
cable is pushed through and the cable is splayed open a bit, then
pulled back in to the cup and soldered.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|