Mike, See below......
----- Original Message -----
From: "Michael Gladwin" <michaelgladwin@mac.com>
To: "Healey List" <healeys@autox.team.net>
Sent: Sunday, June 22, 2008 4:17 PM
Subject: [Healeys] Labels
> Gents:
> Could someone explain to me what the small aluminium
> triangular label is on the top of the float chamber cover. Fitted
> under the retaining screw. Mine are stamped AUD 18F (front): AUD18F
> (middle): AUD618 (rear). The carbs are triple H.S.4's on my BT7 MkII.
These are S.U. carb assembly part numbers.
>
> I also note that, in the BMC manual, the forward carb float chamber
> cover has a fuel inlet and an outlet to feed carb #2. However, mine
> has a T adaptor after the rubber feed line; before the #1 carb line
> this then feeds carb #1 and carb #2 in parallel and not in series.
> The T seems to me to be home-made. Any comments?
You're right...later home done modifications.
Rich Chrysler
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|