From: ampole@hotmail.comTo: linwoodrose@mac.comSubject: RE: [Healeys] BT7 Rear
Hub Stud RemovalDate: Sun, 1 Jun 2008 06:29:33 +0000
Lin Easiest way with the hub removed is to put a socket over the head of the
stud and squeeze it in a vice, then to reinstall put the socket over the other
threaded side and again squeeze in a vice.No need to put in the freezer, its
very easy. You can do it with the hub still on the axle, but you may have to
pull the hub forward to have enough room to get the old stud (hammer) out and
put the new one in between the hub and backplate (with a load of washers as
Michael suggested).Theres a picture on my website of a stud being reinstalled:
http://www.austin-healey3000.com/apps/photos/photo.jsp?photoID=5132641 cheers
andy
Get fish-slapping on Messenger! Play Now
_________________________________________________________________
http://clk.atdmt.com/UKM/go/msnnkmgl0010000002ukm/direct/01/
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|