List:
I have 2 finishing questions that my shop and I can't find the right answer
to:
1. There is a polished stainless steel oval chanelled finishing
strip that fits around the inside of an opening in the bottom counsel where
the gear shifter comes through. It appears this oval piece could fit upside
down with a larger exposed edge upside or thinner edge exposed upside. It
fits a whole lot better with the narrow edge up and another BJ8 in the shop
has it fitted that way. Which way is correct and which direction is the
break/edge-in front or behind the shifter?
2. The aluminum alloy door trim plates were poorly fitted and I am
about to reorder from British Car Specialists their Kilmartin. Any advice
there and how neat does that fit have to be where the two larger pieces
meet.
Dan
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|